Question 1

Will this cable actually enable parking mode on my specific dashcam?

Accepted Answer

It can, but compatibility varies. The cable provides constant power and an accessory (ACC) signal to *tell* your camera when the car is on or off. Many users with Viofo, BlackVue, and Nextbase cams report success. However, some dashcam models require very specific voltage signals to trigger parking mode, which this universal cable may not provide. For guaranteed parking mode functionality, your dashcam's official hardwire kit is often the safest bet. Check your camera's manual for its parking mode trigger requirements.

Question 2

How does the low-voltage protection work to prevent a dead car battery?

Accepted Answer

The cable has a built-in voltage monitor. When your car is off and the cable is powering your dashcam in parking mode, it constantly checks the car battery's voltage. If the voltage drops to a pre-set safety level (typically around 11.8V - 12.4V, designed to leave enough charge to start your car), it automatically cuts power to the dashcam. This is a "set-it-and-forget-it" feature praised by users for its reliability.

Question 3

Is the 11.5ft / 3.5m cable long enough, and is the right-angle connector a problem?

Accepted Answer

For most sedans, SUVs, and trucks, 11.5ft is ample to route from the OBD-II port (usually under the driver's dashboard) up the door frame, across the headliner, and to the center of your windshield. The right-angle USB-C connector is great for keeping the cable flush against the windshield. A small number of users note that in very tight OBD port locations, the angle can be awkward to plug in initially, but once connected, it creates a very clean, low-profile setup.

Question 4

The instructions are unclear. What do the LED indicator lights mean?

Accepted Answer

This is a common point of feedback. Here's a simple breakdown:
*   Solid Green: The cable is plugged into the OBD port and your car is ON (ACC mode).
*   Solid Red: The cable is plugged in and your car is OFF, providing constant power for parking mode.
*   Blinking Red: The low-voltage protection has been triggered and power has been cut to protect your car battery. Start your car to reset it.
*   No Light: Check connections. If firmly connected and the car is on, there may be an issue with the cable or your OBD port.

Question 5

I'm not handy with car electronics. Is this truly easy to install?

Accepted Answer

Yes, this is its biggest advantage. As echoed in countless reviews, it's the simplest alternative to hardwiring. You don't need to touch a fuse box. Simply plug the OBD-II connector into your car's diagnostic port (always powered), route the cable along your vehicle's trim (tools are rarely needed), and plug the USB-C end into your dashcam. The whole process takes most users under 10 minutes for a clean, permanent-looking installation.

CERRXIAN OBD Power Cable for Dash Camera OBD2 to Type C Adapter Hardwire Charger Cable 24 Hours Surveillance/Acc Mode with Low Voltage Protection 13-40V to 5V 3A (11.5FT/3.5M) (Right Angle USB C)

購入前に知っておきたいこと

気になるポイント

分析結果を理解する